Cooking
odes
TEMPERATURE PROBE
[] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] []
For many foods, especially roasts and poultry, testing the internal temperature is the best
method to insure properly cooked food. The Temperature Probe gets the exact temperature
you desire without having to guess. This feature can be used with Bake, Convection Bake,
Convection Roast and Perfect Turkey cooking modes. The oven can be programmed for
Probe at any temperature between 130°F to 210°F with a default temperature of 170°F. This
unit is equipped with one temperature probe entry in the upper oven.
IMPORTANT:
1. Use only the probe supplied with your appliance; any other may result in damage to the
probe or the appliance.
2. Handle the Temperature Probe carefullywhen inserting and removing it from thefood and outlet.
3. Do notuse tongs topullthe cablewhen insertingor removingthe Probe. Itcoulddamagethe Probe.
4. Defrost your food completely before inserting the Probe to avoid breaking it.
5. Never leave or store the Temperature Probe inside the oven when not in use.
6. To prevent the possibility of burns, carefully unplug the Temperature Probe using hot
Proper Temperature Probe Placement:
1. Always insert the probe so that the tip rests in the center of
thebone,thickeStfat,gristlePartOforthepan.meat.Do not allow probe to touch
2. For bone-in ham or lamb, insert the Probe into the center of
the lowest large muscle or joint. For dishes such as meat loaf or Figure1
casseroles, insert the Probe intothe center of the food. When cookingfish,
insert the Probe from just above the gill into the meatiest area, parallel to the backbone.
3. For whole poultry (chicken, turkey, etc.), insert the probe into the thickest part of the inner
thigh from below and parallel to the leg (see figure 1).
Setting the Oven when using the Temperature Probe:
1. Insert the Temperature Probe into the food (see Proper Temperature Probe Placement above).
2. Plug the Temperature Probe into its outlet in the oven. (The outlet is located on the top
left hand side of the cavity wall, near front of the oven). Always insert the probe into
a cool oven. Make sure it is pushed all the way into the outlet. Close the oven door.
UPPER
3. Select oven by pressing either UPPER OVEN OVEN.
4. Select a cooking mode. A target temperature must be set to trigger the buzzer when the food
reaches the set temperature. Press COOK OPTIONS ('v_ to bring up the cook options items
and press PROBE _ pad to enter the temperature. Adjust temperature tothe desired setting
using the numeric+pads or just press START _ to use the default target temperature of
170°F. The pads hi or io can also be pressed to raise or lower the temperature. The target
temperature setting will be accepted after the START _J_ pad is pressed.
5. At any time during the cooking, the PROBE _ pad can be pressed once to display the
actual meat temperature or pressed twice to display the target temperature. When on
the target temperature display, a new temperature can be entered. After 5-8 seconds,
the display will go back to showing the oven temperature.
6. When the food reach the target temperature, the oven will go into a KEEP WARM mode
until you press CANCEL @).
The probe can be damaged by very high temperature. To protect the probe against this
damage, the oven controlwill not allow you to start aself-clean,broil or convection broil
while the probe is connected.
To Next Page
Loading...
Need help?
General
