Setting
urface Controls
SETTINGTHECOOKTOP(CONTINUED/
[] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] []
Setting cooktop elements
• if needed, wake the control panel.
• Touch the ON OFF key for the desired heating zone.
• Press the desired power level key (hi+, med or Io-) or for more precise level settings use
the hi+ or Io- keys to make specific level changes.
Hot Element (HE) Message
After using any of the induction heating zones, the ceramic cooktop will become very hot
from heat transferred by the cookware. Even after turning the control off, the cooktop will
remain hot for some time.
The cooktop control monitors the temperature of the cooktop surface and displays a
message "HE" (hot element) and flashes the burner ring when the cooktop is still too
hot to touch -Fig. 1-. If the HE message remains displayed in the LCD, the heating zone
may be set again and used for cooking.
Suggested cooktop power settings
Use the chart below to determine the suggested setting for the type of food you are
preparing when using the cooktop.
Recommended Surface Settings Chart
Setting TypeofCooking
POWER BOOST (Pb)
HIGH (8-HI)
MEDIUM (6)
MEDIUM LOW (4- 5)
LOW (Lo-3)
Start most foods; bring water to a boil and pan broiling.
Continue a rapid boil; frying, deep fat frying.
Maintain a slow boil; thicken sauces and gravies; steaming
vegetables.
Keep foods cooking; poaching and stewing.
Keep warm, melting and simmering.
Fig. 1
To Next Page
Loading...
Need help?
General
