SOI 04.05 FV 18/57 599 36 62-62
4.4.2 SENSOR CONTROL INTERFACE CIRCUIT BOARDS
This hob is provided with a touch sensor control
device.
To insert the controls in the hob, some sensors
interface electronic PCBs are used in place of the
normal buttons which control the switches placed in
the control unit.
The system consists of sensor PCBs placed under
the glass which recognise the presence of a finger
at a distance of about 4 mm from the sensors (glass
thickness).
The sensor PCBs include different control units with
touch sensors used on the basis of the control
software (see Fig. 9, 10 and 11).
Fig. 9
The functions of the various controls and of the LEDs and displays are listed below.
Fig. 10
ON / OFF
BR-S/R 1 BURNER
ON/OFF - REAR LEFT BURNER
BR-S/R 1 RESIDUAL
HEAT LED
RESIDUAL HEAT - REAR LEFT
BURNER
BR-S/R 1 FLAME
LEVEL LEDS
FLAME LEVEL LEDs - REAR
LEFT BURNER
BR-S/R 1
DECREASING
FLAME
DECREASE FLAME - REAR
LEFT BURNER
BR-S/R 1
INCREASING
FLAME
INCREASE FLAME - REAR LEFT
BURNER
ON / OFF
BR-R BURNER
ON/OFF - FRONT LEFT
BURNER
BR-R RESIDUAL
HEAT LED
RESIDUAL HEAT - FRONT
LEFT BURNER
BR-R FLAME
LEVEL LEDS
FLAME LEVEL LEDs - FRONT
LEFT BURNER
BR-R
DECREASING
FLAME
DECREASE FLAME - FRONT
LEFT BURNER
BR-R
INCREASING
FLAME
INCREASE FLAME - FRONT
LEFT BURNER
BOARD FOR LEFT FRONT AND
LEFT REAR SECTIONS
To Next Page
Loading...
Need help?
General
