Electrolux Hob User Manual

SOI 04.05 FV 37/57 599 36 62-62
8. TROUBLE-SHOOTING
8.1 TROUBLE-SHOOTING USING ERROR CODES
Trouble-shooting using error codes identifies the component or the exact section of the circuit in
which the fault has occurred.
When the control circuit detects a malfunction, the error code is displayed and depending on the
code, the operation of the burner is stopped or the appliance is switched off. Before executing a
trouble-shooting, check the error code as explained in the chapter “Error codes” and then unlock
the burner or the whole system (see chapter “Automatic burner switch-off”).
8.1.1 ERRORS WITH BURNER BLOCK
The error codes with block of the burner are the following:
1, 2, 3, 4, 5, 6, 7, 8, 10 e 14.
Control Result Cause Solution
E
r
ror code
1
(ignition
failed
)
Check for the
presence of
sparks.
The spark is
regular.
Check for the
presence of
gas.
No gas at the input
connection.
No gas output or
gas tap open.
Open the gas
or control the
system.
The spark is not
correct
(anomalous
dischar
g
es
)
.
Condition
Gas at the input
connection.
Check for the
burner cap
position and
that the flame
warms up the
thermocouple.
Incorrect
distribution of the
flame.
Position
correctly the
cap (clean the
burner if
necessar
y)
.
The cap is wrongly
positioned.
The position of the
cap is correct and
the flame warms up
the thermocouple
correctly.
Check for the
thermocouple
connection
relative to the
burner.
Incorrect signal
from the
thermocouple to
the power board.
Reset the
connection and
eventually
clean the
contacts.
The connection is
not loose.
The connection is
correct.
Thermocouple
faulty.
Replace the
thermocouple.
Power board
faulty.
Replace the
power board.
1

Electrolux Hob Specifications

General

Brand	Electrolux
Model	Hob
Category	Hob
Language	English