0209 8
3
01106073
Page
Notice
Date
OPERATING
HANDBOOK
Cooling mode
When the STOP
function is requested during
operation, the machine will switch to standby and the
heating system will be switched off.
The screen will remain in this mode as long as the
temperature of the cylinder remains above 100°C
(212°F).
The screen then displays the following message.
Warm-up
STOP RST-CNT NEXT
Stand by
START
You can now switch off the machine.
RST-CNT resets the sheet counter.
Cooling mode
Automatic mode
Warm-up
MANU NEXT
Warm-up
As soon as the machine is turned on, the "Start
heating" command is given. The cylinder temperature
begins to rise.
By default, the machine is set for automatic mode.
The service screen appears as soon as the sheets
have been inserted or when the required temperature
is reached.
Mx 160°C 2.0m/mn 000
DIAMMS NEXT
Selection of the automatic mode
When it starts up, the machine is set for automatic
mode by default. However, you can switch over to
manual mode at any time.
The "
M" in the upper left-hand corner shows that you
are in manual mode. To return to automatic mode,
all you need to do is to press once on the "DIAMMS"
button.
The "X" behind the letter "M" can take several forms:
• "F" if you have chosen the "FIX" folding mode.
• "P", if you have chosen the "PLIVIT" folding mode.
• If nothing is shown, this means that folding is
deactivated.
3. Method of use
Cool-Down : xx°C
START
To Next Page
Loading...
Need help?
General
