EMC B Series User Manual

36
EMC Connectrix B Series DS-300B Hardware Reference Manual
Operating the DS-300B
Powering the DS-300B on and off
To power on the DS-300B, connect the power cable to the AC
receptacle on the switch and to a power source. The switch runs
POST by default each time it is powered on, reset, or rebooted, and
requires a up to three minutes to run.
To end the flow of power to the DS-300B, remove the power cord
from the power source.

EMC B Series Specifications

General

Brand	EMC
Model	B Series
Category	Network Hardware
Language	English