Epson CMOS 32-Bit Single Chip Microcomputer S1C33L03 User Manual

III PERIPHERAL BLOCK: SERIAL INTERFACE
S1C33L03 FUNCTION PART EPSON B-III-8-23
A-1
B-III
SIF
Control and Operation of IrDA Interface
The transmit/receive procedures have been explained in the section on the asynchronous interface, so refer to
"Control and Operation of Asynchronous Transfer".
The following describes the data modulation and demodulation performed using the PPM modulator circuit:
When transmitting
During data transmission, the pulse width of the serial interface output signal is set to 3/16 before the signal is
output from the SOUTx pin.
TCLK
PPM modulator input (I/F output)
PPM modulator output (SOUTx)
123 891011 16
3×TCLK
16×TCLK
Figure 8.16 Data Modulation by PPM Circuit
When receiving
During data reception, the pulse width of the input signal from SINx is set to 16/3 before the signal is
transferred to the serial interface.
TCLK
PPM modulator input (SINx)
PPM modulator output (I/F input)
1 234 16
16×TCLK
3×TCLK
Figure 8.17 Demodulation by PPM Circuit
Note: When using the IrDA interface, set the internal division ratio of the serial interface 1/16 (DIVMDx =
"1"), rather than 1/8 (DIVMDx = "0").

Epson CMOS 32-Bit Single Chip Microcomputer S1C33L03 Specifications

General

Brand	Epson
Model	CMOS 32-Bit Single Chip Microcomputer S1C33L03
Category	Computer Hardware
Language	English