Epson CMOS 32-Bit Single Chip Microcomputer S1C33L03 User Manual

VI SDRAM CONTROLLER BLOCK: SDRAM INTERFACE
S1C33L03 FUNCTION PART EPSON B-VI-2-33
A-1
B-VI
SDRAM
Examples of SDRAM Controller Initialization Program
The following shows examples of the initialization program for using SDRAM.
Example of initialization routine for 2M words × 16 bits × 4 banks (16MB) of SDRAM
INIT_SDRAM_16MB:
;;;----------------------- SDRAM access configuration -----------------------------------
;;;*****************************************************************
;;;***************** C33 macro setting part ************************
;;;*****************************************************************
;;; set CEFUNC to use #CE13/14 (upper area) ... 1 (See "SDRAM Controller Configuration".)
xld.w %r0,0x48131
bset [%r0],0x1
;;; set area 6,13,14 to internal access ... 2, 5, B-1
xld.w %r0,0x48132
xld.w %r1,0x2200
ld.h [%r0], %r1
;;; area 6 -> output disable 0.5, wait 2 ... 3
xld.w %r0,0x4812A
xld.w %r1,0x0237
ld.h [%r0],%r1
;;; available #WAIT ... 4
xld.w %r0,0x04812E
bset [%r0],0x0
;;; area 13,14 -> 16bit device, output disable 2.5, wait 0 ... B-2, B-3, B-4
xld.w %r0,0x048122
xld.w %r1,0x30
ld.h [%r0],%r1
;;;*****************************************************************
;;;************** SDRAM Controller REG setting part ****************
;;;*****************************************************************
;;;-------------------------------------------------
;;;area13 0x2000000 - 0x2FFFFFF(16MB)
;;;area14 0x3000000 - 0x3FFFFFF(16MB)
;;;-------------------------------------------------
;///////////////////////////////////////////
;;; SDRAM area configuration register ... (note 1)
xld.w %r0,0x39FFC0 ;
xld.w %r1,0x88 ; set area13 to SDRAM area, #SDCE0(#CE13) available
ld.b [%r0],%r1 ; (16MB area available)
;///////////////////////////////////////////
;;; SDRAM control register
;;; xld.w %r0,0x39FFC1 ;
;;; xld.w %r1,0xff ; SDRAM self-refresh -> disable, initial sequence ->PRE REF MRS
;;; ld.b %r0],%r1 ; Little endian
;///////////////////////////////////////////
;;; SDRAM address configuration register ... (note 2)
xld.w %r0,0x39FFC2 ;
xld.w %r1,0x26 ; col 512 / row 4K / bank 4 -> 128Mb[16MB] available
ld.b [%r0],%r1 ;
;///////////////////////////////////////////
;;; SDRAM mode set-up register
xld.w %r0,0x39FFC3 ;
xld.w %r1,0x40 ; 2 CAS Latency ,burst length = 1
ld.b [%r0],%r1 ;
;///////////////////////////////////////////
;;; SDRAM timing set-up register 1
xld.w %r0,0x39FFC4 ;
xld.w %r1,0x4A ; Tras=2,Trp=1,Trc=2 ... Recommended setting to operate with
ld.b [%r0],%r1 ; 25 MHz clock in x1 speed mode
;///////////////////////////////////////////
;;; SDRAM timing set-up register 2
xld.w %r0,0x39FFC5 ;
xld.w %r1,0x48 ; Trcd=1,Trsc=2,Trrd=1
ld.b [%r0],%r1 ;
;///////////////////////////////////////////
;;; SDRAM auto refresh count low-order register
;;; xld.w %r0,0x39FFC6 ;
;;; xld.w %r1,0xff ;
;;; ld.b [%r0],%r1 ;
;///////////////////////////////////////////

Epson CMOS 32-Bit Single Chip Microcomputer S1C33L03 Specifications

General

Brand	Epson
Model	CMOS 32-Bit Single Chip Microcomputer S1C33L03
Category	Computer Hardware
Language	English