Adjusting the Image
44
Viewing the Image at the Saved Image Quality
(Memory Function)
Saving a Memory
By using the memory function, you can register settings for Image from the Configuration menu, and then
load them when necessary.
a
Make the settings or adjustments you
want to register.
b
Press the [Memory] button.
c
Use the up and down buttons to select
Save Memory, and then press the
[Enter] button to confirm the
selection.
d
Use the up and down buttons to select
the memory name you want to save,
and then press the [Enter] button to
confirm the selection.
The current projector settings are saved to
the memory.
If the mark on the left of the memory name
is turned aqua, it means the memory has
already been registered. When you select a
registered memory, a message is displayed
asking you to confirm that you want to
overwrite the memory. If you select Yes, the
previous content is erased and the current
settings are saved.
Loading, Deleting, and Renaming a Memory
You can load, delete, and rename registered memories.
Press the [Memory] button, and then select the target function on the screen displayed.
Function Explanation
Load Memory
Loads the saved memory. When you select a memory and press the
[Enter] button, the settings applied to the current image are replaced with
the settings from the memory.
Erase Memory
Erases a saved memory. When you select a memory name and press the
[Enter] button, a message is displayed. Select Yes, and then press the
[Enter] button to erase the selected memory.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
