EasyManuals Logo
Home>Epson>Projector>EH-TW7000

Epson EH-TW7000 User Manual

Epson EH-TW7000
112 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #76 background imageLoading...
Page #76 background image
Troubleshooting
75
Problems relating to images
No images appear
Check Remedy
Is the power turned on? Press the power button on the remote control or the standby
button the control panel to turn on the projector.
Is the power cord connected? Connect the power cord.
Are the indicators switched off? Disconnect and then reconnect the projector's power cord.
Check that pressing the power button after connection supplies
the projector with power.
Is an image signal being input?
Check that the connected device is turned on. When Messag-
es is set to On from the Configuration menu, image signal mes-
sages are displayed.
s Extended - Display - Messages p.65
Has the power to the AV amplifier been dis-
connected?
If an AV amplifier is connected, check the AV amplifier's power
supply.
Is an image signal being sent from the device? Check that an image signal is being sent from the connected
device.
Are the Configuration menu settings correct?
Reset all of the settings.
s Reset - Reset All Config p.70
(Only when projecting computer image sig-
nals)
Was the connection made while the power of
the projector or the computer was already
turned on?
If the connection is made while the power is already turned on,
the Fn key (Function key) that changes the computer's image
signal to external output may not work. Turn off the power for
the computer and the projector and then turn it back on again.
Moving images are not displayed
Check Remedy
(Only when projecting computer image sig-
nals)
Is the computer's image signal set to external
output and to output to the LCD monitor at
the same time?
Depending on the computer's specifications, moving images
may not be displayed when the computer is set to external out-
put and to the LCD monitor output at the same time.
Change it so that the image signal is set to external output only.
For the computer's specifications, see the documentation sup-
plied with the computer.
"Not supported" is displayed
Check Remedy
(Only when projecting computer image sig-
nals)
Do the image signal's frequency and resolu-
tion correspond to the mode?
Check the image signal being input in Resolution from the Con-
figuration menu, and check that it corresponds to the projector's
resolution.
s Info - Projector Info p.70
s "Supported Resolutions" p.95

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Epson EH-TW7000 and is the answer not in the manual?

Epson EH-TW7000 Specifications

General IconGeneral
Matrix size0.61 \
Number of colors1.07 billion colors
Native aspect ratio16:9
Projection distance2.95 - 4.77 m
Vertical scan range192 - 240 Hz
Projection technology3LCD
Contrast ratio (typical)40000:1
Screen size compatibility40 - 500 \
Projector native resolution2160p (3840x2160)
Keystone correction, horizontal-30 - 30 °
Noise level32 dB
Country of originPhilippines
2D/3D frequency image240/480 Hz
Noise level (economic mode)24 dB
Built-in speaker(s)No
Lamp typeUHE
Lamp power250 W
Light source typeLamp
Service life of light source3500 h
Service life of light source (economic mode)5000 h
FocusManual
Throw ratio1.32 - 2.15:1
Zoom capabilityYes
Focal length range18.2 - 29.2 mm
Aperture range (F-F)1.49 - 1.77
Vertical lens shift range-60 - 60 %
Horizontal lens shift range-24 - 24 %
PlacementCeiling, Desktop
Product typeStandard throw projector
Product colorWhite
Market positioningHome cinema
Cable lock slot typeKensington
Video processing10 bit
Video color modesAuto, Cinema, Dynamic, Natural, Bright cinema
Supported 3D formatsSide by side, Top and bottom
Supported video modes2160p
Supported 3D technologiesSamsung Active 3D
Analog signal format system-
Supported graphics resolutions3840 x 2160
Power sourceAC
AC input voltage100-240 V
AC input frequency50 - 60 Hz
Power consumption (standby)0.5 W
Power consumption (typical)368 W
Power consumption (PowerSave)280 W
Serial interface typeRS-232C
USB 2.0 ports quantity2
VGA (D-Sub) ports quantity0
Mini-USB 2.0 ports quantity1
Storage temperature (T-T)-10 - 60 °C
Operating temperature (T-T)5 - 30 °C
Storage relative humidity (H-H)10 - 90 %
Operating relative humidity (H-H)20 - 80 %
Pallet weight0 g
Quantity per pack1 pc(s)
Quantity per pallet18 pc(s)
Quantity per pallet (UK)36 pc(s)
Quantity per pallet layer2 pc(s)
Harmonized System (HS) code85286200
Quantity per pallet layer (UK)4 pc(s)
Weight and Dimensions IconWeight and Dimensions
Depth310 mm
Width410 mm
Height157 mm
Weight6600 g
Package depth495 mm
Package height230 mm
Package weight8710 g

Related product manuals