Configuration Menu
66
Function Menu/Settings Explanation
Operation
Direct Power
On
On, Off You can set up the projector so that projection
starts as soon as the power cord is plugged in
without any button operations.
Note that when this is set to On, projection starts
if power is restored after a blackout or other
power outage and the power cord is still plugged
into the projector.
Sleep Mode On, Off If the set time is exceeded and no signal is input,
the projector is automatically turned off and en-
ters standby mode. When in standby mode,
press the power button on the remote control or
the standby button on the control panel to re-
start projection.
Sleep Mode
Timer
1 to 30 mins.
Sets the interval for Sleep Mode.
Illumination On, Off
Set this to Off if the light from the indicators on
the control panel bother you when watching a
movie in a dark room.
Trigger Out* Off, Power, Anamorphic
Wide
Set the Trigger Out function to communicate the
projector's power on status and so on to external
devices.
When set to Off, no voltage is output from the
Trigger Out port.
When set to Power, voltage is output from the
Trigger Out port when the projector is on.
For Anamorphic Wide, when the projector is on
and Aspect is set to Anamorphic Wide or Horiz.
Squeeze, voltage is output from the Trigger
Out port.
If you change this setting, the new setting will
take effect the next time you turn the projector
on.
High Altitude
Mode
On, Off
Set this to On if you are using the projector above
an altitude of 1500 meters.
Log Save Des-
tination
Internal Memory, USB and
Internal Memory
Set where you want to save the logs.
Standby Mode
Communication Off, Communication On
Communication On indicates that the projector
can be monitored over a network when the pro-
jector is in standby mode.
Language
- Selects the display language.
Reset
Yes, No
Resets all Extended settings except for Memo-
ry, Projection, High Altitude Mode, Standby
Mode, and Language.
*
EH-TW7100 only.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
