61
Maintenance
The projector has a built-in counter which keeps track of the lamp
operating time. When the cumulative operating time reaches a certain
point, it causes the replacement warning message to be displayed.
Therefore, the counter needs to be reset after the lamp has been replaced
with a new one. You can do this using the configuration menu.
PROCEDURE
A
Connect the power cable and turn on the projector.
B
Select "Reset" from the configuration menu, and then
select "Lamp-Hours reset".
For details on this operation, refer to
"Using the Configuration
Menu
". sp.32
Check the buttons you can use, and the operations they
perform, in the guide at the bottom of the screen.
C
When "Execute?" appears, select "Yes".
The lamp operating time will then be reset.
Resetting the Lamp Operating Time
Do not reset the lamp operating time except after the
lamp has been replaced, otherwise the lamp replacement
period will not be indicated correctly.
Using the remote control
Using the control panel
To Next Page
Loading...
Need help?
General
