Epson EMP-S3 User Manual

70
List of ESC/VP21 Commands
USB Connection Setup
In order to control the projector using ESC/VP21 commands via a USB
connection, the following preparations must be carried out.
PROCEDURE
A
Download the USB driver (USB-COM Driver) from the
EPSON website to your computer.
The URL is as follows.
http://www.epson.co.uk/support/download/index.htm
B
Install the downloaded USB driver onto your
computer.
Read the instructions displayed on the download screen.
C
Change the "Link21L" setting in the "Extended" menu
to "ON".
D
Turn the projector's power off.
E
Turn off this projector after the confirmation buzzer
beeps twice.
Once the projector's power has turned back on, communication
via a USB Connection will then be possible.
If you disconnect the power cable before the
confirmation buzzer beeps twice, the communication
port is not changed.

Epson EMP-S3 Specifications

General

Brand	Epson
Model	EMP-S3
Category	Projector
Language	English