Printing on Single Sheets
You can use the paper guide to print on single sheets with a width
of 182 mm (7.2 inches) to 257 mm (10.1 inches).
Note:
You can install an optional cut-sheet feeder to load up to 50 sheets
automatically. See page 2-24 for details.
Loading single sheets
You load single sheets as shown in “Running the Self Test” in
Chapter 1. For normal use, turn on the printer without pressing
any other buttons. When the printer receives data, it begins to
print.
c
Caution:
Use the knob on the right side of the printer only to clear paper
jams and only when the printer is off. Otherwise, you may
damage the printer or cause it to lose the top-of-form position.
Adjusting the loading position
If you want to adjust the position where printing begins on the
page, follow these steps (these instructions also work when using
the pull or push tractor):
1. With paper loaded, hold down the
PAUSE
button until the
printer beeps once and the
FONT
lights begin to flash.
2. Press the
LF/FF
button to feed the paper forward, or press the
FONT
button to feed the paper backward. (Press either button
as many times as necessary until you reach the desired
position.)
3. To complete the adjustment, press the
PAUSE
button or send
data from your computer.
R
Blueberry REV.F
A5 size Chapter 2
95/05/25
Using the Printer
2-5
To Next Page
Loading...
Need help?
General
