Epson LX-810 User Manual

Paper Handling
The following section guides you through problems in handling
single sheets and continuous paper. If you are having problems
using the optional cut sheet feeder, pull tractor, or roll paper
holder, refer to the section on Options starting on 7-22.
Problem
Solution
Single sheets do not
feed properly.
When the
LOAD/EJECT button
is pressed, the
platen does not
rotate and paper
does not feed.
When the
LOAD/EJECT button
is pressed, the
platen rotates but
paper does not feed.
You may be trying to feed paper while the
printer is on line (ON LINE light is on).
Press the ON LINE button once to set the
printer off line; then feed the paper. After
feeding the paper, press the ON LINE
button again to set the printer on line.
Refer to 3-3.
The paper may be set too far to the right,
so that the paper detector cannot sense it.
Move the paper a little to the left. The
PAPER OUT light should go off.
The paper release lever may be pulled
forward to the continuous paper position.
Push the paper release lever back to the
single sheet position. Refer to 2-2.
The left and right edge guides may be too
close together, preventing the paper from
feeding smoothly. Adjust the position of
the edge guides so that the paper can
move up and down freely. Refer to 2-4.
7-14 Troubleshooting

Epson LX-810 Specifications

General

Brand	Epson
Model	LX-810
Category	Printer
Language	English