Epson WorkForce WF-M1030 User Manual

Notices
Check these sections for important notices about your product.
Note: Epson offers a recycling program for end of life products. Please go to www.epson.com/recycle for
information on how to return your products for proper disposal.
FCC Compliance Statement
Software Notices
Trademarks
Copyright Notice
FCC Compliance Statement
For United States Users
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio or television reception. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause interference to radio and television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
WARNING
The connection of a non-shielded equipment interface cable to this equipment will invalidate the FCC
Certification or Declaration of this device and may cause interference levels which exceed the limits
established by the FCC for this equipment. It is the responsibility of the user to obtain and use a shielded
equipment interface cable with this device. If this equipment has more than one interface connector, do
not leave cables connected to unused interfaces. Changes or modifications not expressly approved by
the manufacturer could void the user’s authority to operate the equipment.
104

Epson WorkForce WF-M1030 Specifications

Printing Specifications

maximum print resolution	1440 x 720 optimized dpi
maximum print speed	34 ppm
ISO print speed	15.0 ISO ppm
minimum ink droplet size	3 picoliters

Connectivity

standard connectivity	Hi-Speed USB
wireless connectivity	802.11 b/g/n
ethernet connectivity	10/100

Paper Handling

maximum paper size	8.5" x 44"
input paper capacity	100 sheets plain paper, 10 envelopes
duplex printing	manual

Operating Environment

operating temperature	50 ° to 95 °F (10 ° to 35 °C)
storage temperature	-4 ° to 104 °F (-20 ° to 40 °C)
operating relative humidity	20 – 80%

Power

rated voltage	100 – 240 V
rated frequency	50 – 60 Hz
rated current	0.6 Amp

Weight and Dimensions

printing dimensions (W x D x H)	15.4" x 20.9" x 11.7"
storage dimensions (W x D x H)	15.4" x 10.4" x 5.8"
weight	7.1 lb