Epson WorkForce WF-M1030 User Manual

Light status Condition/solution
An unknown product error has occurred. Turn the product off. Make
The power, paper, and
sure no paper is jammed in the product, then turn the product back on
ink lights are flashing fast
again. If the error continues, contact Epson for support.
An error has occurred during firmware updating. Connect your product
The paper and ink lights
using a USB cable and try downloading the Firmware Update from
are on
Epson's support website. If the error continues, contact Epson for
support.
Note: The ink pads in the printer collect, distribute, and contain the ink that is not used on printed pages.
During the life of your product it may reach a condition where either satisfactory print quality cannot be
maintained or the ink pads have reached the end of their usable life. The Epson Status Monitor, your
LCD, or lights on the control panel will advise you when these parts need replacing. If this happens
during the standard warranty of the product, the exchange of the product or replacement of the pads is
covered under the standard warranty. If the product is out of warranty, the pads can be replaced by any
Epson authorized service provider. The waste ink pads are not a user-serviceable part.
Parent topic: Solving Problems
Related references
Paper Jam Problems
Where to Get Help
Related topics
Loading Paper
Running a Product Check
Running a product check helps you determine if the printer is operating properly.
1. Press the power button to turn off the printer.
2. Disconnect any interface cables connected to your product.
3. Load plain paper in the product.
73

Epson WorkForce WF-M1030 Specifications

Printing Specifications

maximum print resolution	1440 x 720 optimized dpi
maximum print speed	34 ppm
ISO print speed	15.0 ISO ppm
minimum ink droplet size	3 picoliters

Connectivity

standard connectivity	Hi-Speed USB
wireless connectivity	802.11 b/g/n
ethernet connectivity	10/100

Paper Handling

maximum paper size	8.5" x 44"
input paper capacity	100 sheets plain paper, 10 envelopes
duplex printing	manual

Operating Environment

operating temperature	50 ° to 95 °F (10 ° to 35 °C)
storage temperature	-4 ° to 104 °F (-20 ° to 40 °C)
operating relative humidity	20 – 80%

Power

rated voltage	100 – 240 V
rated frequency	50 – 60 Hz
rated current	0.6 Amp

Weight and Dimensions

printing dimensions (W x D x H)	15.4" x 20.9" x 11.7"
storage dimensions (W x D x H)	15.4" x 10.4" x 5.8"
weight	7.1 lb