Epson WorkForce WF-M1030 User Manual

Product Does Not Appear in Mac OS X Printer Window
If your product does not appear in the Mac OS X printer window, try these solutions:
• Turn your product off, wait 30 seconds, then turn it back on again.
• If you are connecting the product via Wi-Fi Protected Setup (WPS) and the WiFi light on your product
is not solid green, make sure you press the Wi-Fi button on the product within 2 minutes of pressing
the WPS button on your router. Hold down the Wi-Fi button on the product for 3 seconds.
• If you are connecting the product wirelessly via EpsonNet Setup and the WiFi light on your product is
not solid green, make sure your product software was installed correctly. If necessary, reinstall your
software.
Parent topic: Solving Network Problems
Cannot Print Over a Network
If you cannot print over a network, try these solutions:
• Make sure that your product is turned on.
• Make sure you install your product's network software as described in your product documentation.
• Print a network status sheet and verify that the network settings are correct. If the network status is
Disconnected, check any cable connections and turn your product off and then on again.
• If you are using TCP/IP, make sure the product's IP address is set correctly for your network. If your
network does not assign IP addresses using DHCP, set the IP address manually.
• Make sure your computer and product are both using the same wireless network.
• If network printing is slow, print a network status sheet and check the signal strength. If it is poor, place
your product closer to your router or access point.
Note: Avoid placing your product near a microwave oven, 2.4 GHz cordless phone, or large metal
object, such as a filing cabinet.
• If you are connecting the product via Wi-Fi Protected Setup (WPS) and the WiFi light on your product
is not solid green, make sure you press the Wi-Fi button on the product within 2 minutes of pressing
the WPS button on your router. Hold down the Wi-Fi button on the product for 3 seconds.
• Check your wired LAN router or access point to see if the LED for the port to which your product is
connected is on or flashing . If the link LED is off, try the following:
• Make sure the Ethernet cable is securely connected to your product and to your router, access
point, switch, or hub.
78

Epson WorkForce WF-M1030 Specifications

Printing Specifications

maximum print resolution	1440 x 720 optimized dpi
maximum print speed	34 ppm
ISO print speed	15.0 ISO ppm
minimum ink droplet size	3 picoliters

Connectivity

standard connectivity	Hi-Speed USB
wireless connectivity	802.11 b/g/n
ethernet connectivity	10/100

Paper Handling

maximum paper size	8.5" x 44"
input paper capacity	100 sheets plain paper, 10 envelopes
duplex printing	manual

Operating Environment

operating temperature	50 ° to 95 °F (10 ° to 35 °C)
storage temperature	-4 ° to 104 °F (-20 ° to 40 °C)
operating relative humidity	20 – 80%

Power

rated voltage	100 – 240 V
rated frequency	50 – 60 Hz
rated current	0.6 Amp

Weight and Dimensions

printing dimensions (W x D x H)	15.4" x 20.9" x 11.7"
storage dimensions (W x D x H)	15.4" x 10.4" x 5.8"
weight	7.1 lb