Epygi QX series Configuring

Configuring Epygi QX IP PBXs with BINARY NETWORKS
Figure 2: VoIP Carrier Wizard- Page 2
3. On the third page of the VoIP Carrier Wizard define the Access Code (let’s say 0) which will be used in
the
Call Routing Table for making outgoing calls to BINARY NETWORK, and the IP PBX extension
which will receive all incoming calls from
BINARY NETWORKS SIP trunks. Routing all incoming calls to
the Auto Attendant (00) is the most frequently used scenario. Defining another extension as the call
receiver also applicable.
 Access Code – 0
 Emergency Code – leave the default value or put your country emergency call, let’s say 000.
 Route Incoming Calls to – 00.
Enable the Failover to PSTN service if it is desirable to allow calls failover through the IP PBX onboard
FXO lines and press the
Next button (Figure 3).
Revision 1.0 6 1-Oct-15

Epygi QX series Specifications

General

Brand	Epygi
Model	QX series
Category	PBX
Language	English