Epygi QX series Configuring

Configuring Epygi QX IP PBXs with BINARY NETWORKS
1 Introduction
This document describes the configuration of Epygi QX IP PBXs (herein IP PBX) to use the SIP trunking service
from
BINARY NETWORKS. The IP PBX is capable of making IP-PSTN calls via BINARY NETWORKS SIP
trunks. This solution allows IP PBX users to make cost saving calls to the global PSTN.
Please Note: The described configuration is generic for all QX IP PBX models.
Please Note: Security issues and calling rates are beyond the scope of this document. See the listed
documents in
References section to get more information on the security related issues.
2 Scenario
Provider: BINARY NETWORKS
• offers outbound and inbound calls.
• allows parallel outbound calls to be made from one account.
• allows parallel calls to be received to one account.
Customer:
• will be able to make long distance PSTN calls through BINARY NETWORKS SIP trunks.
2.1 Requirements and Preparations
• The IP PBX is connected to the network and all network settings are properly configured.
• The IP PBX is running software version 6.1.x or higher.
2.2 Account Information from BINARY NETWORKS
BINARY NETWORKS will provide the customer with the following data:
• Username – 61390208487 (sample)
• Password - ************
• SIP Server - sip.binaryvoice.com.au
• Signaling port for SIP server - 5060
• Telephone Number(s) – a single DID or groups of DIDs of 5, 10, 20 or 100.
Please Note: The above listed values have demonstrational purposes.
3 Configuration
Sections below describe the configuration required on the IP PBX allowing to:
• Make and receive long distance IP-PSTN calls through BINARY NETWORKS SIP trunks.
• Send and receive faxes through BINARY NETWORKS SIP trunks.
Revision 1.0 4 1-Oct-15

Epygi QX series Specifications

General

Brand	Epygi
Model	QX series
Category	PBX
Language	English