Epygi QX series Configuring

Configuring Epygi QX IP PBXs with BINARY NETWORKS
As a result of above listed steps, the provided account is configured on the automatically created extension
989 and the routing rule
0* is automatically added to the Call Routing table. This allows making outbound calls
through
BINARY NETWORK SIP trunks using 0 prefix when dialing, as well as receiving inbound calls to the
extension 989 (
Figure 5).
Figure 5: Call Routing Table page
How this rule works: The system will route all dialed digits matching the 0 prefix through BINARY
NETWORKS SIP trunks to PSTN.
3.2 Configuration for Receiving Inbound Calls from BINARY NETWORKS
There are a couple of ways to allow incoming calls to be received from BINARY NETWORKS SIP trunks.
1. One is already done in 3.1. For receiving incoming calls from BINARY NETWORKS SIP trunks, the
required configuration is already created through the
VoIP Carrier Wizard, so now all incoming calls to
the DID number 61390208487 will go to the extension 989 and then automatically forwarded to the
extension 00, which is the system Auto Attendant (
Figure 6).
Revision 1.0 8 1-Oct-15

Epygi QX series Specifications

General

Brand	Epygi
Model	QX series
Category	PBX
Language	English