Epygi QX series User Manual

Hidden Pages for QX Advanced Configuration
a notification signal. If this checkbox is not selected, the system will detect only Caller IDs that
are transmitted after a notification signal.
Ring Confirmation Time: Minimum length of the ringing signal (in ms) required for the system to
validate an incoming call. Ringing signals shorter than the specified time will be ignored by the
system.
All settings found on this page are automatically adjusted to the regional settings set in the System
Configuration Wizard. It is strongly recommended to leave the settings with their default values
unless the characteristics of a specific PSTN line differ from those predefined for the region.
Please Note: For the instructions on how to determine the correct values for FXO settings
appropriate to your CO, please see the troubleshooting guide FXO Diagnostics, which is available in
the Support Portal of the www.epygi.com
.
3.6 Fxoconfig
The FXO Settings page allows configuring each FXO line (see Figure 9). As opposed to the
fxocfg.cgi responsible for all FXO lines’ common settings, the fxoconfig.cgi allows distinct
configuration of each FXO line.
Figure 9: FXO Settings page
• To modify the settings of an FXO line, click on the link associated with the line on the FXO
Settings page. This will open the FXO Settings page for the selected line and enable to
configure the below listed settings.
Figure 10: FXO Settings page for FXO 2
Revision 1.0 13 20-Feb-15

Epygi QX series Specifications

General

Brand	Epygi
Model	QX series
Category	PBX
Language	English