25 / 62
8 • Adjustment
80116-276_V24169
2022-01
CHAPTER 8
Adjustment
Personnel requirements
Temperature conditions
ATTENTION! Adjustments, technical tests, modifications, maintenance and repair
work may only be performed by Erbe or persons trained by Erbe. If the
work is not performed by trained persons, Erbe accepts no liability and
warranty rights become void.
IMPORTANT! Measurement/adjustment should take place when the unit has
warmed up (standby temperature). For this purpose, switch on the unit
and wait until the temperature attains a constant value. This value is
between +40
°C and +55 °C and is attained after approx. half an hour.
(This value is displayed in the test program "TP generator", for exam
-
ple.)
To Next Page
Loading...
Need help?
General
