GENERAL MENU
BASIC INSTRUCTIONS
The following recommendations must be followed the rst times
the stove is ignited:
It is possible that slight odours are produced due to the drying
of the paints and silicone used. Do not remain in the room for long
periods.
Do not touch the surfaces as they could still be unstable.
Ventilate the room well several times.
The hardening of surfaces will stop after several heating cycles.
This appliance must not be used to burn waste.
Before lighting the stove, the following points must be checked:
The hopper must be loaded with pellets
The combustion chamber must be clean
The burn pot must be completely free and clean
Check the hermetic closure of the hoper, re door and ash
drawer
Check that the power cable is properly connected
The bipolar switch in the rear must be positioned on 1.
AIR
(Ventilation)
RPM
(Speed)
EASY
(Pellet calibration)
CRNO
(Chrono)
ABIL
(Enable)
PRG1
(PROGRAMMING 1)
PRG2
(PROGRAMMING 2)
SET
(Settings)
DATE
(Date)
PRG3
(PROGRAMMING 3)
DAY
(Day)
PRG4
(PROGRAMMING 4)
TIME
(Time)
LNG
(Language)
STBY
(Stand-by)
DELT
(Delta-T)
*STAT
(Status)
CF
(Celsius/Fahrenheit)
RES
(Reset)
*TECHNICIANS ONLY
*TECH
(Technical Menu)
1
ON/OFF BUTTON - EXIT MENU
2
SCROLL UP - CONFIRM
3
SCROLL DOWN
4
PRESS AND HOLD TO ACCESS MENU - ACCESS SELECTED MENU -
INCREASE VALUE
5
DECREASE VALUE
2
1
1
2
3
4
5
To Next Page
Loading...
Need help?
General
