Extraflame LUISELLA User Manual

18
ENGLISH
AIR VENTILATION
The menu allows you to adjust the speed (-2, -1, 0, +1, +2) of the front fan.
CONTROLS PROCEDURE
 Press and hold key 4.
 Access AIR. with key 4.
 Access RPM with key 4.
 Adjust speed with keys 4-5 and 2 to conrm.
 Press key 1 several times to exit the menu.
EASY PELLET CALIBRATION
The volumetric weight of the pellet is the ratio between the weight and the volume of the pellet. This ratio may change while keeping the
quality of the pellet unchanged. By using the EASY function, it is possible to change the calibration of the volumetric weight by increasing
or decreasing the pre-set values.
In the stove program, the available values go from “– 3” to “+ 3”; all stoves are calibrated during production with the optimal value which is 0
If you notice an excessive deposit on the burning pot, access the EASY program and lower the value of one unit to “- 1”; then wait until the
next day and if there is no improvement, decrease again, to a maximum of “- 3”. Instead, if it is necessary to increase the calibration of the
volumetric weight of the pellet, go from the factory value “0” to “+ 1, + 2, + 3” as required.
CONTROLS PROCEDURE
 Press and hold key 4.
 Press key 3 until EASY appears and access with key 4.
 Adjust using keys 4 and 5 and conrm with key 2.
 Press key 1 several times to exit the menu.
EXCESSIVE PELLET DEPOSIT IN THE BURNING POT NORMAL OPERATION MINIMUM PELLET DEPOSIT IN THE BURNING POT
-3 -2 -1 0 +1 +2 +3
THIRD DECREASE
RANGE IF THE
FIRST TWO ARE
NOT ENOUGH
SECOND
DECREASE
RANGE IF THE
FIRST IS NOT
ENOUGH
FIRST DECREASE
RANGE (TEST FOR
1 DAY )
OPTIMAL FACTORY
VALUE
FIRST INCREASE
RANGE
SECOND
INCREASE RANGE
IF THE FIRST IS
NOT ENOUGH
THIRD INCREASE
RANGE IF THE
FIRST TWO ARE
NOT ENOUGH
N.B.: If this calibration does not solve the pellet deposit in the burn pot, please contact your local after-sales centre.
IT IS FORBIDDEN TO USE THE DEVICE WITHOUT A PARTITION A AND FLAME
GUARD B.
REMOVAL WILL COMPROMISE THE SAFETY OF THE PRODUCT AND RESULT
IN THE IMMEDIATE NULLIFICATION OF THE WARRANTY PERIOD.
IN THE EVENT OF WEAR OR DETERIORATION, REQUEST THE PART'S
REPLACEMENT FROM THE AFTERSALES SERVICE.
REPLACEMENT DOES NOT FALL WITHIN THE PRODUCT WARRANTY AS THE
PART IS SUBJECT TO WEAR.
A
B

Extraflame LUISELLA Specifications

General

Brand	Extraflame
Model	LUISELLA
Category	Stove
Language	English