0.1.5 Update software
Option that permits the software of the existing cards to be updated. The new software to be
recorded will be taken via USB. To update the new software, use the key.
When the software is updated, the washing machine configuration is maintained together with
that of the existing programmes and the list of programmes in favourites. A SW update will update the
application and the factory programmes and configurations. The programmes created by the user or
which have been modified from the library are maintained.
To return to the factory conditions after updating the SW, run “factory parameters” afterwards.
Press to return to the SAT screen.
0.2 Autotest
On the main maintenance screen, select the icon to go to autotest. This option allows
you to view the status of all the inputs, and to activate any of the outputs in order to test the correct
operation of the different machine components (the inputs/outputs are displayed according to the
configuration of existing kits).
The inputs and outputs which are available in ALL the machines are ALWAYS displayed. The
inputs and outputs which are exclusive to a particular feature (for example, Self-service, Sanitary, Extra
dispensers, Tanks (T1, T2, T3), Tilting…) will only be available if the feature is activated.
On leaving the output activation screen, all the outputs are deactivated.
It is also possible to run a programme that helps to test the machine, guiding the user through
the machine test process.
Select the Autotest option, and the following screen is displayed.
To Next Page
Loading...
Need help?
General
