2.4 Turn off the Printer
2.4.1 Clean Stop Normally
1. Press the F1 key to start the jet stop sequence. The default
sequence is Clean Stop. The clean stopping sequence takes
approximately two minutes. The interface is as follow:
Figure 2-9. Stopping interface.
2. During the sequence, you can open the front cover of the print
head to observe if the printer head is dirty. You can flush the dirty.
3. When the jet stop sequence is complete, the interface is as
follow. Press the main power switch to turn off the printer.
Figure 2-10. the stop sequence complete interface.
2.4.2 Clean stop (Power failure during the usage)
It will be abnormal switch off, if there is a power failure during the usage.
The printer should process the starting jet and clean stopping jet at once
when power on.
2.4.3 Clean stop (long term shutdown)
Clean the pipe system, if the Printer will not be used for a long time.
To Next Page
Loading...
Need help?
General
