Fav 900
Engine / Lubrication
Removing and refitting oil pan
G
Repair
Fav 900 chassis number 23/3001 and up
14.02.2001
2312 000003
G
a
2/3
Capitel Docu-No.
Index
Date Version
Page
Removing and refitting oil pan
PM-Picturemodule
PM-Picturemodule
PM-Picturemodule
PM-Picturemodule
PMTAB_Picture
Remove screws from flywheel housing ( 3 on
each side of engine).
Position jack with cradle inderneath the oil pan
and remove all externally accessible screws from
the oil pan.
Note:
For ease of reassembling, note the screws
sequence (I.e. short / long).
PMTAB_Picture
Insert two (M8*20)screws at the rear of the oil pan
(arrowed) and slowly press down the oil pan.
Clean the oil pan and remove all gasket residue
from pan and intermediate flange.
PMTAB_Picture
Removing the oil intake line
Remove screws from the bracket (2)
Remove screws from intake pipe flange(1).
Remove intake pipe and gasket.
Note:
Avoid dirt contamination of the oil duct.
PMTAB_Picture
Refitting oil intake pipe
Position intake pipe and new gasket and insert
screws by hand.
After fitting the bracket, tighten scews to specified
torque. Replace O-rings.
To Next Page
Loading...
General