Fermax SMILE 3.5” Monitor User Manual

Page 16
SMILE VDSSMILE VDS
SMILE VDSSMILE VDS
SMILE VDS
SMILE VDSSMILE VDS
SMILE VDSSMILE VDS
SMILE VDS
6. Exit Programming: When you press  you exit to the previous programming menu.
Continue pressing  until you exit programming. The monitor will also automatically
exit programming mode after 60 seconds of inactivity.
Note:
- Upon exiting programming, the wildcard button stops blinking, indicating that the
monitor is programmed.
When the monitor has not been programmed.
2. The administrator code option is selected
as default (white line under the icon).
Press . The following screen will appear
1. Access the ADMINISTRATOR menu Press "Menu" for 3 seconds.
. The following
screen appears
3. This option programmed by the VDS #
monitor is selected as default. The
selected option is displayed on the white
line under the icon.
The first thing the monitor then does is
indicate the number of the current monitor
on the SCREEN. If it is not programmed, it
will show the following: - - -
Notice: The wildcard button blinking
(red) indicates that the monitor has not
been programmed.
Option 2: from the Monitor Monitors can be programmed on the screen menu.
_ _ _
_ _ _
2222
4444
Notice:
- The wildcard button will continue blinking (red) until having exited programming.
4. Program the call number: Press on the
previous screen and access the screen
to program the residence´s number.
The first number is blinking, each time you
press + or - it increases or decreases this
number.
When the corresponding number has
been programmed you reach the previous
menu via the back arrow.
0 0 1

Fermax SMILE 3.5” Monitor Specifications

General

Brand	Fermax
Model	SMILE 3.5” Monitor
Category	Intercom System
Language	English