Regular Maintenance
MAINTENANCE SCHEDULE & PROCEDURES
The following schedule should be followed for normal care of your rider and mower. You will need to keep a record of
your operating time. Determining operating time is easily accomplished by observing the elapsed time recorded by
the hour meter.
See Before Before Every Every Every Spring
SAFETY ITEMS Page First Use Each Use 5 Hours 25 Hours 100 Hours & Fall
Check Safety Interlock System 7 ●●
Check Rider Brakes 26 ●●
Check Mower Blade Stopping Time 28 ●●
See Before Before Every Every Every Spring
NORMAL CARE ITEMS Page First Use Each Use 5 Hours 25 Hours 100 Hours & Fall
Check Rider/Mower for loose hardware — ●●
Check Engine Oil Level 17* ●●● ●
Check Engine Air Filter 17* ● ***●
Check Engine Coolant Level 18* ●
Clean Radiator & Screen 18* ●
Change Engine Oil & Filter ** 17* ***● Every 50 Hours ***●
Check / Adjust PTO Clutch 28 ****●
Lubricate Rider & Mower 19 ***●
Check Tire Pressure 16 ● ***●
Check Hydraulic Fluid 17 ● ***●
Check Fuel Filter 17 ●
Clean Battery & Cables 20 ●
Clean & Sharpen Mower Blades 21 ●
Inspect Spark Plugs 17* ●
* See the engine manufacturer's owner's manual.
** Change original engine oil after first 5 hours of operation.
*** More often in hot (over 85° F: 30° C) weather or dusty operating conditions.
**** Service after the first 25 hours, then after every 100 hours.
Tire Pressure
Front 25 psi (1,72 bar)
Rear 15 psi (1,03 bar)
Figure 10. Checking Tire Pressure
CHECK TIRE PRESSURES
Tire pressure should be checked periodically, and main-
tained at the levels shown in the chart. Note that these
pressures may differ slightly from the “Max Inflation”
stamped on the side-wall of the tires. The pressures
shown provide proper traction, improve cut quality, and
extend tire life.
16
To Next Page
Loading...
Need help?
General
