Ferris IS3000z Series User Manual

Troubleshooting, Adjustment & Service
CUTTING HEIGHT ADJUSTMENT
The cutting height adjustment pin (A, Figure 34) controls
the mower cutting height. The cutting height is
adjustable between 1-1/2” (3,8cm) and 5” (12,7cm) in
1/4” (0,64cm) increments.
Depress the deck lift foot pedal (B), placing the majority
of the force on the top edge of the pedal until it locks
into the “TRANSPORT” position. Place the cutting
height adjustment pin in the desired cutting height.
Depress the deck lift foot pedal, placing the majority of
the force on the bottom edge of the pedal to release the
pedal from the “TRANSPORT” position.
WARNING
Before checking mower, shut off PTO and engine.
Allow all moving parts to stop. Remove ignition
key, then disconnect the spark plug wire and
fasten it away from the spark plug.
A
B
C
Figure 34. Cutting Height Adjustment
A. Cutting Height Adjustment Pin
B. Deck Lift Foot Pedal
C. Cutting Height Selection Decal
29

Ferris IS3000z Series Specifications

General

Brand	Ferris
Model	IS3000z Series
Category	Lawn Mower
Language	English