– 17 –
ARMING ALL PROTECTION
(With Entry Delay ON)
Using the
2 AWAY Key
Use this key when no one will be staying on the premises.
When armed in AWAY mode, the system will sound an alarm if a protected door or window is
opened, or if any movement is detected inside the premises. You may leave through the
entrance door during the exit delay period without causing an alarm. You may also re-enter
through the entrance door, but must disarm the system within the entry delay period or an alarm
will occur.
Close all protected perimeter windows and doors before arming (see CHECKING FOR
OPEN ZONES section). The green READY indicator on the keypad should be lit if the system is
ready to be armed.
AWAY
1. + 2 ENTER SECURITY CODE THEN PRESS AWAY
(Security Code)
Example: 7 2 9 6 then press the AWAY key.
2.
ARMED
**
AWAY
**
YOU MAY E XIT NOW
The "You May Exit Now"
portion of the message
disappears when the exit
delay expires.
LISTEN
The keypad will beep twice, or beep continuously if an exit
warning has been programmed for your system, and
displays the armed AWAY message. The red ARMED
indicator also lights.
2-Partition AWAY
Arming
In a two-partition system, you can arm both partitions in the AWAY mode at the same time if the
same master code is assigned to both partitions. You can do this from either partition's keypad.
This procedure is not applicable to disarming or any other system function.
(Continued)
To Next Page
Loading...
Need help?
General
