– 20 –
DISARMING AND SILENCING ALARMS
Using the
1 OFF Key
Use the OFF key to disarm the system and to silence alarm and trouble sounds. See
"SUMMARY OF AUDIBLE NOTIFICATIONS" section for information which will help you to
distinguish between FIRE and BURGLARY alarm sounds.
IMPORTANT: If you return and the main burglary sounder is on, DO NOT enter the premises,
but call the police from a nearby safe location. If you return after an alarm has occurred and
the main sounder has shut itself off, the keypad will beep rapidly upon entering, indicating that
an alarm has occurred during your absence and an intruder may still be on the premises.
LEAVE IMMEDIATELY and CONTACT THE POLICE from a nearby safe location.
To disarm the system and silence burglary alarms:
OFF
1. + 1 ENTER SECURITY CODE, THEN PRESS OFF
(Security Code)
Example: 7 2 9 6 then press the OFF key.
2.
***
DISARMED
***
READY TO ARM
LISTEN FOR 1 BEEP
The “Ready” message will be displayed (if no alarms have
occurred while armed) and the keypad will beep once to
confirm that the system is disarmed.
Memory of Alarm If an alarm occurs, the keypad displays the zone number (s) that caused the alarm and the type
of alarm. These messages remain displayed until cleared by a user. To clear the display, note
the zone number displayed and repeat step 1 above. If the “Ready“ message will not display,
go to the displayed zone and correct the fault (close windows, etc.). If the fault cannot be
corrected, notify your alarm company.
To Next Page
Loading...
Need help?
General
