143
SAFETY
STARTING
AND DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
TECHNICAL
SPECIFICATIONS
INDEX
KNOWING
YOUR CAR
SERVICING
AND CARE
SPRAY NOZZLES
Windscreen washer fig. 8
If the jet of fluid is inadequate, firstly
check that there is fluid in the reservoir:
see “Checking fluid levels” in this
chapter).
Then check that the nozzle holes
are not clogged, if necessary clean
them using a needle.
The windscreen jets are directed
by adjusting the nozzle angle.
The jets must be directed at about
1
/
3
of the height from the window
upper edge.
WARNING In versions with a sun roof,
make sure that the sun roof is closed
before operating the front jets.
Rear window washer fig. 9
The rear window washer jets are fixed.
The nozzle holder is on the rear window.
fig. 8
KA00079m
fig. 9
KA00080m
BODYWORK
PROTECTION FROM
ATMOSPHERIC AGENTS
The main causes of corrosion are
the following:
❒
atmospheric pollution;
❒
salty air and humidity (coastal areas,
or hot humid climates);
❒
seasonal environmental conditions.
The abrasive action of wind-borne
atmospheric dust and sand, as well
as mud and gravel raised by other
cars is also not to be underestimated.
On your car, Ford implemented
the best manufacturing technologies
to effectively protect the bodywork
against corrosion.
These include:
❒
painting products and systems which
give the car particular resistance
to corrosion and abrasion;
❒
use of galvanised (or pretreated)
steel sheets, with high resistance
to corrosion;
133-146 Ford KA EN_131-148 Ford KA IT 08/04/14 08:39 Pagina 143
To Next Page
Loading...
Need help?
General
