Program levels P1 - P3
Access
1
Switch on the power source while holding down the operating mode (3) or process
(18) button. The display shows "---" for level preferences.
2
Press the torch trigger until
- --- appears .... "Program level preferences”
- P1 appears ... Program level service menu
- P2 appears ... Program level code lock
- P3 appears ... Program level AC parameters
3
Release mode (3) or process (18) button
Select and
change setup
parameters
1
Select the desired parameter using the operating mode (3) or process (18) button
2
Change the parameter value using the torch trigger
Program level
service menu P1
Service menu with various test programs
Program level
code lock P2
When the power source is delivered, the code lock is deactivated.
It is possible to enter a three-digit code.
Factory setting 321
NOTE!
If the code is entered incorrectly three times (ERR), the power source automatic-
ally switches to "LOC". The procedure must be repeated by switching off and on
again.
Important! Changes to the number combination must be noted in writing.
1
Select program level P2
2
Enter current code (for new devices 321)
- Set digit with main current controller IH (14)
- Confirm digit with operating mode button (3)
- Repeat the procedure twice until "Cod OFF" appears on the display.
3
Switch to "Cod ON" with torch trigger
4
CYC ... Cycle indicates how often the device can be switched on without having to
enter a code.
5
Set the number of cycles with the torch trigger and confirm with the operating mode
key (3)
Enter new numerical code:
1
Select 0-9 / A-H by means of the torch trigger
2
Press the operating mode key (3) to confirm the entry
3
Repeat procedure twice until code is entered
4
Press the torch trigger
61
EN-US
To Next Page
Loading...
Need help?
General
