Page 15
Don’t forget to push the levers back in again firmly after manually positioning the chair
WARNING! Do not use your chair in freewheel mode or attempt to place your
chair into freewheel mode without an attendant present. You may cause
injury to yourself and to others. Do not place your power chair in freewheel
mode while on an incline. The chair could roll uncontrollably on its own,
leading to injury to yourself and others.
WARNING! When the power wheelchair is in freewheel mode, the braking
system is disengaged.
5.4 Electrical Safety Protection
Your wheelchair has a fuse fitted into the battery circuit to protect the motors and electronics
from an accidental current overload. In the case of a blown fuse, the chair will not drive and
you will need to contact your Magic Mobility dealer for repair / replacement
5.5 Seat Tilt Option – if fitted
To operate the seat tilt:
Bring your power chair to a complete stop on a flat level surface.
Always fasten the positioning belt when operating the seat tilt option.
Push the ‘Accessory Mode Selection’ button on the DX2 joystick. Select
seat tilt by moving the joystick left or right. Once the seat tilt option is
highlighted (as shown to the right), moving the joystick forward or
backwards will operate the function.
Once the seat reaches its highest tilt angle, the tilt action stops; release the joystick at
this point.
Before driving, return the seat to its upright position. When returning to the upright
position, always be sure that the mechanism has reached its lowest limit or normal
seated position.
WARNING! Never tilt the seat from its upright position on an inclined surface or
on bumpy or uneven surfaces. Never raise the seat tilt while your power chair
is in freewheel mode. Failure to heed this warning can result in the power chair
tipping over and causing personal injury.
CRITICAL! Do not put your fingers, toes or any objects into the tilt mechanism
while it is operating. Serious personal injury will occur.
5.6 Power elevating seat option – if fitted
The power elevating seat will allow more freedom and independence by
extending your level of reach. The seat height can be adjusted to match a
surface to which you are transferring.
The scissor action of the seat elevator may be a dangerous hazard. Under no circumstances
should you put your hands, fingers, toes or any part of your body in the seat elevator
mechanism while it is operating. Ensure that no one in the vicinity of the wheelchair has any
part of their body in the seat elevator mechanism while it is working.
To operate the power elevating seat:
Bring your power chair to a complete stop on a flat level surface.
Always fasten the positioning belt when operating the power elevating seat.
To Next Page
Loading...
Need help?
General