EasyManuals Logo
Home>Frontier>Wheelchair>V6

Frontier V6 User Manual

Frontier V6
42 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #17 background imageLoading...
Page #17 background image
Page 17
6 Joystick controls
A detailed manual for the DX2 joystick is available from Dynamic Control’s website:
www.dynamiccontrols.com.
The joystick controls may be customised and may be one of a number of different models
depending upon users requirements. This manual contains detailed information on the
standard joystick control.
6.1 Joystick power
If the power chair begins to move in an unexpected manner, immediately release the joystick
and turn the wheelchair off. Unless the joystick is damaged, this should stop your power
chair.
If the joystick is not in the neutral (centre) position when you turn on the power, you may
cause a fault in the system. Releasing the joystick and turning the power off and on again will
reset the system.
WARNING! Always turn the power off when you are stationary to
prevent unexpected movement.
6.2 Rain and Water
The joystick hand control unit IS NOT WATERPROOF. The joystick module is splash proof
but may be permanently damaged if water transgresses the rubber seals (this damage is not
covered under warranty).
We recommend carrying a plastic bag large enough to cover the joystick module and
the user’s hand, in case of rain.
6.3 Joystick lead
If for any reason, the joystick lead is disconnected take care when reconnecting, do not force
the plug into the socket. The lead is polarised and should only be fitted one way.
STOP! Forcing the plug into the socket the wrong way can
permanently damage the electronics system. Also, do not place the
lead so that it can be pinched in the seat frame or the power base
frame.
6.4 Controller program
The controller program affects speed, acceleration, deceleration, and braking. The drive
mode settings are preset at the factory. If your Magic Mobility Dealer/ healthcare professional
changes these settings, please make note of these changes.
WARNING! Do not attempt to reprogram your chair. Only the power
chair manufacturer, an authorised representative of the manufacturer,
or a trained service technician should program the controller.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Frontier V6 and is the answer not in the manual?

Frontier V6 Specifications

General IconGeneral
BrandFrontier
ModelV6
CategoryWheelchair
LanguageEnglish