Page 33
Appendix A - ANSI/RESNA WC/Vol 1 – Section 19 &
ISO7176-19 restraint system; if fitted
The wheelchair is not provided with a wheelchair anchored belt restraint as standard. It must
be requested at the time of ordering the wheelchair or it can be retrofitted later on by a Magic
Mobility Representative.
Once fitted; the wheelchair complies with the requirements of RESNA WC-4, Section 19 and
ISO7176-19.
It is recommended that people who use wheelchairs should transfer to the vehicle seat and
use the vehicle-installed occupant restraint system when this is feasible.
When seat positioning options are fitted the following should be followed unless necessary
for postural or medical requirements of the occupant.
Seat elevator: fully DOWN i.e. the seat at its lowest
Seat Tilt: Fully DOWN i.e. the seat parallel to the ground
Legrest: Fully DOWN i.e. feet close to the floor, knees bent at 90°
Backrest: Upright i.e. at or close to 90° to the seat
Figure 5 - V6 Tie Down Locations
There are four wheelchair securement points; two at the front and two at the rear.
To Next Page
Loading...
Need help?
General