-12-
Reference Guide - Main Unit
1.
Pull out the paper tray until it stops.
2.
When paper is already loaded in the tray, take out the
paper.
3.
Pinch the guide clip, and adjust to the correct paper
size.
4.
Fan a stack of paper, face the print surface up, and then
load the paper with edges aligned according to the
direction of the arrow.
Important
Do not load paper above the maximum fill line. It
may cause paper jams or machine malfunction.
5.
Push in the paper tray.
Loading special paper
Hole Punched paper
Paper orientation: Load paper with holes facing the left side when viewed from the front of the machine
Bypass Tray
The Paper Tray 5 (Bypass) allows you to use a variety of paper sizes and types that cannot be used in Stan-
dard Trays and Tandem Tray.
The bottom face of loaded paper is the surface printed on.
Loadable paper
1.
Open the paper tray.
Paper size Width 88.9 to 320 mm
Length 98.4 to 1,200 mm
Paper weight Single side printing 52 to 300 g/m
2
Maximum number of sheets 90 sheets (80 g/m
2
paper)
To Next Page
Loading...
Need help?
General
