Fuji Xerox ApeosPort-V 6080 User Manual

15 Problem Solving
426
Problem Solving
15
The Print Result is Not What was Expected
If the print result is not what was expected, identify the symptom in the following table to
perform the remedy.
Symptom Cause Remedy
Outputs are not
stapled.
The Finisher is not installed. The Finisher is required to staple. Install the
Finisher, or change the print option settings
to cancel stapling.
The number of pages to be
stapled exceeds the
maximum number for
stapling.
Reduce papers to be less than the maximum
number for stapling.
The maximum number of pages for stapling varies
depending on the used finisher. For more information,
refer to "Specifications" (P.604).
The 2-sided
printing is not
available.
The print page buffer is
insufficient.
Try the followings:
z
Set [Image Quality] to [Standard] using the
print driver
z
Set the port that is not used to [Disable]
Paper is not
folded.
The Folder Unit is not
installed.
Check the optional components installed on
the machine, and reconfigure the printer
configuration.
The document is
printed on a
different paper
size than
specified.
The document size is different
from the paper size loaded in
the specified tray.
Change the size of paper in the tray, or
change the print option to specify a tray that
contains the correct sized paper.
The image on the
document edges
is missing on the
output.
The image is larger than the
printable area.
Expand the printable area of the machine, or
reduce the image size on the printout.
The printed font
differs from the
font specified on
the computer.
Font replacement is set on
the print driver.
Check the font replacement table.
The printout is not
offset.
The machine does not offer
the Offset feature.
To output offset, the Offset Stacking Module
or the Finisher is required.
Printing is slow. [High Resolution] is selected
for [Image Quality].
When image data, such as photos, is printed
with the high resolution, the print speed
becomes slow. Select [Standard] for [Image
Quality].
The specified
print options are
not enabled.
The print driver for another
model is used.
Install the print driver for the model.
The required optional kit is
not installed on the machine.
Check the optional components installed on
the machine, and set [Installable Options]
under [Configuration] in the print driver
again.
The document
edges are missing
on the printout.
The image is larger than the
printable area.
Expand the printable area of the machine, or
reduce the image size on the printout.
Black lines are
printed.
A print driver for another
machine is used.
Install the print driver for your machine.

Fuji Xerox ApeosPort-V 6080 Specifications

General

Brand	Fuji Xerox
Model	ApeosPort-V 6080
Category	All in One Printer
Language	English