Fuji Xerox DocuCentre-V C3375 Administrator's Guide

Connectivity & Network Setup
233
Tools
5
the time of transmission with the remotely authenticated user name and password. You can
also select the post-failure behavior of the machine from [Cancel E-mail Send] and [Relogin
using System Data]. If you do not set remote authentication, the machine uses the user ID
and passcode of the machine for authentication.
 SMTP AUTH Login Name
Enter the user name for verification purposes at the SMTP server with up to 64 characters.
 SMTP AUTH Password
Enter the password for verification purposes at the SMTP server. Up to 64 single-byte
characters are allowed.
Note • If you do not set the password, leave the text boxes blank and select [Save].
Remote Authentication/Directory Service
You can make the settings for the remote authentication server and directory service.
Note • DocuCentre series models can only support the services associated with searches for Address Book
of "LDAP Server/Directory Service Settings (ApeosPort Series Models Only)" (P.234).
Authentication System Setup (ApeosPort Series Models Only)
 Authentication System
Allows you to select the authentication system from [Kerberos (Windows 2000)], [Kerberos
(Solaris)], [LDAP], [SMB], and [Authentication Agent].
After you change the authentication system, folders and job flow sheets used with the
previous authentication system are not deleted automatically. If these folders or job flow
sheets are no longer needed, delete them from the machine. If the same user IDs are also
used on the new authentication system, folders and job flow sheets can be used by the same
users.
 Server Response Time-Out
Set the server time-out response between 1 and 75 seconds in 1 second increments.
 Search Time-Out
Set the user information search time-out between 1 and 120 seconds in 1 second
increments.
Kerberos Server Settings (ApeosPort Series Models Only)
Configure the Kerberos Servers 1 to 5.
The settings in [Kerberos Server 1 (Default)] will be the default settings for authentication.
 Primary Server Name/Address
Enter the primary server name or IP address.
Note • For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value from 0 to
255.
• For IPv6, enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where "xxxx" is a
hexadecimal value.
 Primary Server - Port Number
Set the primary server port number from 1 to 65535.
The default value is 88.
Important • Do not use the numbers assigned to the other ports.

Fuji Xerox DocuCentre-V C3375 Specifications

General

Brand	Fuji Xerox
Model	DocuCentre-V C3375
Category	Printer
Language	English