5 Tools
226
Tools
5
HTTP Proxy Server Port Number
Set the HTTP proxy server port number from 1 to 65535.
The default value is 8080.
Important • Do not use the numbers assigned to the other ports.
HTTP Proxy Server Authentication
Select [Enabled] when authentication is required to connect to the HTTP proxy server.
HTTP Proxy Server Login Name
Enter a login name of the HTTP proxy server. Up to 31 characters are allowed.
HTTP Proxy Server Password
Enter a password of the HTTP proxy server. Up to 31 characters are allowed.
SIP Settings
Configure the settings for a SIP user ID, SIP server to go through, and VoIP gateway.
In [SIP Settings], you can set the following items.
SIP User ID (Sign-in Name)
Enter the SIP user name of the machine.
For example: 111@192.0.2.1
The left side of @ (111 in this example) is called the SIP user name.
Note • If you do not use a SIP server, specify the IP address of the machine on the right side of "@".
• When you use a SIP server manufactured by Cisco Systems, Inc. for [SIP User Name] of the machine,
you can use only IPv4 address strings of the SIP server on the right side of "@". You cannot use IPv6
address strings, FQDN strings, and SIP domain name strings.
SIP Transport Protocol
Select the SIP transport protocol from [UDP] or [TCP].
Note • Select [UDP] when you use a SIP server manufactured by Cisco Systems, Inc.
Enable SIP Server
Select whether or not to enable a SIP server.
SIP Server IP Address Resolution
Specify a method for obtaining the IP address for the SIP proxy server and the SIP registrar
server.
Note • Even when IP addresses can be resolved automatically using [DHCP] or [DHCP v6], port number,
login user name, login password, and server type cannot be resolved automatically. Configure these
items manually.
• When you select [DHCP] to automatically obtain the IP address, select [DHCP] or [DHCP/AutoIP] for
[IPv4 - IP Address Resolution] of the TCP/IP settings of the machine.
• If an IP address is resolved automatically, the same IP address is assigned to both a proxy server and
a registrar server. If you use different IP addresses for the proxy server and the registrar server,
configure the IP addresses manually.
If multiple IP addresses are resolved automatically, assign the first IP address to a primary proxy/
registrar server and the second to a secondary proxy/registrar server. The third and subsequent
addresses are not used.
• Even when the IP address is resolved automatically, the port number, login user name, login
password, and server type cannot be automatically obtained. Set these manually.
To Next Page
Loading...
Need help?
General
