Troubleshooting 139
Non-Genuine Mode
When toner within a toner cartridge is empty, a toner indicator lights up or blinks, and at the same time, the (Error)
indicator lights up depending on the printer status. For details on indicators, see "Understanding the Operator Panel
Indicators" on page 98.
When you want to use the printer in the Non-Genuine mode, enable the Non-Genuine mode and replace the toner
cartridge.
IMPORTANT:
• If you use the printer in the Non-Genuine mode, the performance of the printer may not be at its optimum. Any problems that
may arise from the use of the Non-Genuine mode are not covered by our quality guarantee. The continuous use of the Non-
Genuine mode can also cause the printer to break down, and any repair charges for such break down will be incurred by
users.
NOTE:
• To disable the Non-Genuine mode, deselect the check box next to On on the Non-Genuine Mode page on the Printer Setting
Utility.
Using the Printer Setting Utility
The following procedure uses Windows 7 as an example.
1 Click Start All Programs Fuji Xerox Fuji Xerox Printer Software for Asia-Pacific your printer
Printer Setting Utility.
NOTE:
• The window to select a printer appears in this step when multiple print drivers are installed on your computer. In this
case, click the name of the desired printer listed in Printer Name.
The Printer Setting Utility opens.
2 Click the Printer Maintenance tab.
3 Select Non-Genuine Mode from the list at the left side of the page.
The Non-Genuine Mode page is displayed.
4 Select the check box next to On, and then click Apply New Settings.
To Next Page
Loading...
Need help?
General
