To Next Page

To Previous Page

AP-2

* "Multi feed" means that more than 2 papers are fed at the same time.

Paper is not fed (pick error

occurs frequently, or docu-

ment stops midway).

Do the documents satisfy the "Docu-

ment Quality" in Section 2.3.1of the fi-

5015C Operator’s Guide?

Scan the document by Flatbed.

Is the thick document placed on the Flat-

bed?

Is the thick document placed on the Flatbed?

Is the Pick roller unit dirty? Clean the Pick roller unit. Refer to the Operator's

Guide "3.2.3 Cleaning the ADF".

Is the Pick roller unit worn out? Replace the Pick roller unit. Refer to the Opera-

tor's Guide "3.3.4 Replacing the Pick roller unit".

The generated images are

elongated.

Are the Pick roller unit dirty? Clean the Pick roller unit. Refer to the Operator's

Guide "3.2.3 Cleaning the ADF".

There is a shadow on the

leading edge of the gener-

ated image?

Are the Pick roller unit dirty? Clean the Pick roller unit. Refer to the Operator's

Guide "3.2.3 Cleaning the ADF".

Have you adjusted the offset (the scan-

ning starting position)?

Adjust the [Sub-scan Setting] on [Scanners and

Cameras] in the control panel.

Symptom Check this item Remedy

Fujitsu 5015C - fi - Sheetfed Scanner Getting Started

Other manuals for Fujitsu 5015C - fi - Sheetfed Scanner