v
■ Safety Precautions
In the following warnings, "power cable" may
refer to the AC cable connected to the AC adapter
collectively.
Do not damage the AC cable.
Use only specified AC cables and
connector cables
Use this scanner only at the indicated
power voltage. Do not connect to multiple-
power strips.
Do not touch the AC cable with wet hands.
Wipe any dust from the power plug.
Do not install the device in locations that
has oil smoke, steam, humidity, and dust.
Turn the scanner OFF if it is damaged.
Do not put liquids inside the scanner.
Do not touch the inside of the scanner
unless necessary.
Do not use the scanner if there is a strange
odor.
Do not use aerosol sprays near the
scanner.
A damaged AC cable may cause fire or electric
shock.
Be careful of the following when handling the
power cable:
• Do not moisten, modify, tie, bundle, or wind
the cable.
• Do not place heavy objects on the cable, trap
the cable in a doorway, drop or damage the
cable in any other way.
• Do not pull or forcibly bend or twist the cable.
• Do not place any metal near to the plug of
the power cable.
Do not use damaged AC cables or power
plugs, or install any cables or power plugs to
loose wall sockets.
Use only specified AC cables and connector
cables. Failure to use the correct cables might
cause electric shock and/or equipment failure.
Please don’t use the AC cable provided with
this scanner for other devices, since this might
cause equipment failure and other troubles or
an electric shock.
Use this scanner only at the indicated power
voltage and current. Improper power voltage
and current might cause fire or electric shock.
Do not connect to multiple-power strips.
Do not touch the power plug with wet hands.
Doing so might cause electric shock.
Wipe off any dust from the power cable, metal
parts on the power plug or metal fittings with a
soft, dry cloth. Accumulated dust might cause
fire or electric shock.
Do not install the scanner in locations subject
to oil smoke, steam, humidity, and dust. Doing
so might cause a fire or electric shock.
If the scanner is damaged for any reason,
disconnect immediately the power plug in order
to turn out the scanner. Contact the store
where you purchased the scanner.
Do not insert or drop metal objects in to the
scanner. Do not scan wet documents or
documents with paper clips or staples. Do not
splash or allow the scanner to get wet.
If foreign objects (water, small metal objects,
liquids, etc.) get inside the scanner, immediately
turn off the scanner and disconnect the power
plug from the power outlet, then contact the store
where you bought the scanner or the
Maintenance Service Center. Pay particular
attention to this warning in households where
there are small children.
Do not take apart or modify the scanner. The
inside of the scanner contains high-voltage
components. Touching these components might
cause fire or electric shock.
If you detect excessive heat coming from the
device or detect other problems such as smoke,
strange smells or noises, disconnect immediately
the power plug in order to turn out the scanner.
Make sure that any smoke coming from it has
stopped, before contacting the store where you
bought the scanner or an authorized FUJITSU
scanner service provider.
Do not use any aerosol sprays or alcohol
based sprays to clean the scanner.
Dust blown up by strong air from the spray may
enter the inside of the scanner. This may cause
the scanner to fail or malfunction.
Sparks, caused by static electricity, generated
when blowing off dust and dirt from the outside
of the scanner may cause a fire.
To Next Page
Loading...
Need help?
General