2-1-4 OUTDOOR UNIT DISPLAY
2-1-2 SIMPLE REMOTE CONTROLLER DISPLAY
2-1-3 CENTRAL REMOTE CONTROLLER DISPLAY
02-03
Error code
Ex. Error code display
Faulty unit No.
(Remote controller address)
If an error occurs, the following display will be shown.
(
“
“ will appear in the set room temperature display.)
If
“
“ is displayed, immediately contact authorized service personnel.
To show which indoor unit is the error displayed.
indoor unit's name and "ERROR" are alternately shown.
(0.5s indoor unit's name / 0.5s "ERROR")
Ex. Error display
FEDC
MONITOR
ERROR
BA
POWER
MODE
blink
(High-speed)
In the event of an error
Error location display
LEDs A to F of MONITOR light up and display the error location. In the case of an
overall error, LEDs A to F of MONITOR do not light up.
Example) Coil error in indoor unit B
FEDC
MONITOR
ERROR
BA
POWER
MODE
blink
(High-speed)
The error LED frashes quickly.
If an error occurs, the LED will light up to display the error location and the error code.
To Next Page
Loading...
Need help?
General
