Troubleshooting
Troubleshooting
Should an error occur, first check the following points. If the distortion is still not eliminated,
the monitor should, if possible, be checked on another computer.
If you cannot solve the problem, please contact our Service Desk.
Having this problem? Check the following points:
No screen display
Power indicator does not light up
► Check whether the power cable on the
monitor is connected correctly.
► C heck whether the comput
er is switched on.
No screen display
Powerindicatorislit
► C heck whether the computer is switched on.
► Check whether the data cable for the
monitor i s correctly attached to the monitor
port on the computer.
► Press any key on the comp uter keyboard.
The computer may be in power saving
mode.
► Alter the brightness and/or contrast until you
get a picture.
Message: No Signal
► Check whether the data cable for the
monitor i s correctly attached to the monitor
port on the computer.
► C heck whether the computer is switched on.
Message:
Frequency out of range:## kHz / ##
HzPlease change the display mode to
1920 x 1080 with 60 Hz
The input sign
al (horizon tal frequency and
refresh rate
) at the displayed input does not
correspond t
o the technical data for the monitor.
► Adjust the v
ideo frequency range using the
computer so
ftware (see documentation for
the co m pute
r or display adapter).
► Se t a different screen resolution using the
computer software (see documentation for
the co m puter or display adapter).
Daisy Chain d oes not work There may not be enough bandwid th to feed the
second monitor.
► Reduce the display refresh rate and/or the
colour depth in the graphics settings of the
system.
Fujitsu 57