EasyManuals Logo
Home>Fujitsu>Server>PRIMERGY TX2540 M1

Fujitsu PRIMERGY TX2540 M1 User Manual

Fujitsu PRIMERGY TX2540 M1
92 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #46 background imageLoading...
Page #46 background image
46 Operating Manual
TX2540 M1
Important information
4.3 FCC Class A Compliance Statement
If there is an FCC statement on the device, it applies to the products covered in
this manual, unless otherwise specified herein. The statement for other
products will appear in the accompanying documentation.
NOTE:
This equipment has been tested and found to comply with the limits for a
"Class A" digital device, pursuant to Part 15 of the FCC rules and meets all
requirements of the Canadian Interference-Causing Equipment Standard
ICES-003 for digital apparatus. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in strict accordance with the instructions, may cause harmful
interference to radio communications. However, there is no warranty that
interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Fujitsu is not responsible for any radio or television interference caused by
unauthorized modifications of this equipment or the substitution or attachment
of connecting cables and equipment other than those specified by Fujitsu. The
correction of interferences caused by such unauthorized modification,
substitution or attachment will be the responsibility of the user.
The use of shielded I/O cables is required when connecting this equipment to
any and all optional peripheral or host devices. Failure to do so may violate FCC
and ICES rules.
WARNING:
This is a class A product. In a domestic environment this product may cause
radio interference in which case the user may be required to take adequate
measures.

Table of Contents

Other manuals for Fujitsu PRIMERGY TX2540 M1

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fujitsu PRIMERGY TX2540 M1 and is the answer not in the manual?

Fujitsu PRIMERGY TX2540 M1 Specifications

General IconGeneral
Processor socket-
Intel Xeon seriesE5-2400
Built-in processorNo
Motherboard chipsetIntel® C602
Number of processors supported2
Number of DIMM slots12
Supported memory typesDDR3-SDRAM
Maximum internal memory192 GB
RAID levels0, 1, 10
Hot-swap HDD baysYes
Storage drive sizes supported3.5 \
Number of storage drives supported4
Supported storage drive interfacesSerial ATA, Serial Attached SCSI (SAS)
LAN controllerIntel I210
Ethernet LAN data rates10, 100, 1000 Mbit/s
Ethernet interface typeGigabit Ethernet
USB 2.0 ports quantity6
Chassis typeTower
Product colorBlack

Related product manuals