EasyManuals Logo
Home>Fujitsu>Server>PRIMERGY TX2540 M1

Fujitsu PRIMERGY TX2540 M1 User Manual

Fujitsu PRIMERGY TX2540 M1
92 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #91 background imageLoading...
Page #91 background image
TX2540 M1
Operating Manual 91
Troubleshooting and tips
8.9 Added drive reported as defective
RAID controller is not configured for this drive
The drive was probably installed when the system was switched off.
Ê Reconfigure the RAID controller for the drive using the corresponding utility.
Information is provided in the documentation for the RAID controller.
or
Ê Remove and reinstall the drive while the system is switched ON.
If the hard disk drive continues to be shown as defective, then replace it (see
the "FUJITSU Server PRIMERGY TX2540 M1 Server Upgrade and
Maintenance Manual").
I Further information is provided in the "Integrated RAID for SAS User’s
Guide" (on the ServerView Suite DVD under Industry Standard Servers -
Expansion Cards - Storage Adapters - LSI RAID / SCSI Controllers) or in the
"Modular RAID Controller Installation Guide" (on the ServerView Suite
DVD under Industry Standard Servers - Expansion Cards - Storage Adapters -
LSI RAID / SCSI Controllers).
For more information on configuring the controller, see section
"Configuring the server" on page 80.
8.10 Error message on screen
The meaning of the error message is explained in the documentation for the
relevant components and programs on the Fujitsu manuals server.
8.11 Expansion cards or onboard devices not
recognized
When an expansion card is added, other expansion cards or onboard devices
might not be recognized.
Ê Reinstall the drivers for the expansion cards or onboard devices that are not
recognized.

Table of Contents

Other manuals for Fujitsu PRIMERGY TX2540 M1

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fujitsu PRIMERGY TX2540 M1 and is the answer not in the manual?

Fujitsu PRIMERGY TX2540 M1 Specifications

General IconGeneral
Processor socket-
Intel Xeon seriesE5-2400
Built-in processorNo
Motherboard chipsetIntel® C602
Number of processors supported2
Number of DIMM slots12
Supported memory typesDDR3-SDRAM
Maximum internal memory192 GB
RAID levels0, 1, 10
Hot-swap HDD baysYes
Storage drive sizes supported3.5 \
Number of storage drives supported4
Supported storage drive interfacesSerial ATA, Serial Attached SCSI (SAS)
LAN controllerIntel I210
Ethernet LAN data rates10, 100, 1000 Mbit/s
Ethernet interface typeGigabit Ethernet
USB 2.0 ports quantity6
Chassis typeTower
Product colorBlack

Related product manuals