CAUTIONCAUTION
WARNING
Careful consideration is required to avoid
ingress of water through the transducer tank.
The tank shall be strong enough to withstand
the water pressure in fully loaded conditions in
rough weathers. FURUNO Electric Co., Ltd. is
not liable to any loss of ship and personnel
which is caused by installation procedures.
The installer must read the applicable safety instructions before attempting to operate or install the
equipment.
Indicates a potentially hazardous situation which, if not avoided,
could result in death or serious injury.
WARNING
Indicates a potentially hazardous situation which, if not avoided,
can result in minor or moderate injury.
CAUTION
Warning, Caution
Prohibitive Action
Mandatory Action
Ground the equipment to prevent
electrical shock and mutual
interference.
Observe the following safe compass
distances to prevent interference to a
magnetic compass:
Standard
compass
Steering
compass
0.50 m 0.35 m
Display Unit (DS-8500)
2.30 m 1.45 m
Distributor Unit (DS-8510)
1.95 m 1.25 m
2.00 m 1.15 m
Transceiver Unit (DS-8520)
Junction Box (CI-630)
Be sure to power each unit with
proper voltage.
Connection of an improper power supply
can cause fire or damage the equipment.
Do not open the equipment.
This equipment uses high voltage
electricity which can shock, burn or
cause serious injury. Only qualified
personnel can work inside the equipment.
Turn off the power at the mains
switchboard before beginning the
installation.
Fire, electrical shock or serious injury can
result if the power is left on or is applied
while the equipment is being installed.
Do not install the equipment where it
may get wet from rain or water splash.
Water can cause fire or electrical shock,
or damage the equipment.
To Next Page
Loading...
Need help?
General
